Lifebreath CAF-02-MB Bedienungsanleitung PDF herunterladen (Seite 22)

The purpose of this manual is to give the contractor

guidelines for installing the LIFEBREATH Clean Air

Furnace. All national and local codes relating to this

type of equipment must be followed.

Locating The Unit

The Clean Air Furnace is designed to be installed

vertically, (unless it is designated as a Horizontal

unit ”H”), in a conditioned space, where the

surrounding temperature does not fall below

50°F (10°C). Attic installations are not recommended.

Typically the unit is installed in a mechanical area of

the basement, or other partitioned mechanical

room, elsewhere in the home.

A location close to an outside wall is

recommended, as the ventilation supply and

exhaust portion will need to be ducted to the

outside air. Sufficient clearance around the unit is

required for service of the filter, heat recovery

core and components. As a rule this unit should

be installed adjacent to the hot water heater. If

this is not possible, or if the piping layout is

complex, the total head pressure on the pump

should be calculated.

Duct Connections

To accommodate various installations, the Clean

Air Furnace has knockouts for the return air

plenum and ventilation ducts, on both sides of the

cabinet. Special care and attention should be

given to determining which knockouts are to be

removed.

Slide Heat Recovery Core out to remove

ventilation knockouts. Never install ductwork

directly to the cabinet that is smaller than the

opening provided.

Installation

Option 1 - Ventilation Ports Off Left Side

NOTE: Return plenum opening can be on either side of cabinet and is not dependent on which side the ventilation ports are on.

Upflow Models

Downflow Models

Remove circular

metal knockout

Remove

styrofoam

knockout

Remove

styrofoam

knockout

Remove

styrofoam

knockout

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Lifebreath CAF-02-MB Bedienungsanleitung Seite 22

Kommentare zu diesen Handbüchern